Plastic sheet equipment should pay attention to the temperature of the mold during the production process

During the production process of plastic sheet equipment, attention should be paid to the temperature of the mold, and the raw materials should be poured into the mold. The upper mold of the mold can be adjusted. The lower mold is fixed. Therefore, the lower mold must be adjusted before use, and then used in order.

There is an observation port on the mold to facilitate observing whether the product is qualified. If there are unqualified products, the mold or lower mold can be replaced at any time until it is qualified. During the production process, attention should be paid to the temperature of the mold and the temperature of the plastic sheet.

Generally, the temperature of the extruder is controlled by the mold. If the temperature is too high, the product will not be extruded normally, and if the temperature is too low, the product will be extruded unevenly.

During the production process of the extruder, attention should be paid to the screw speed. Generally, the screw speed is directly proportional to the product output. During the production process, it is important to note that the screw speed cannot be too high or too low, which will affect the output and quality of the product.

Pay attention to the temperature of various parts when using the machine. If the temperature of each part is abnormal, product quality and output will be affected.

Pay attention to the temperature of the plastic sheet when using the machine, because if the temperature of the plastic sheet is too high, it will cause the product to deform, crack, and reduce its service life.

Pay attention to production safety issues when using machines. Safety operating procedures must be strictly followed during the production process to avoid safety accidents caused by operational errors. The production efficiency and output of the extruder are determined by its production process. Normally, the output of the extruder is directly proportional to the screw speed and inversely proportional to the molding pressure. This is determined by its structure and working principle. Therefore, operating procedures must be strictly followed when performing extrusion production, otherwise the quality and output of the product will be affected.

(1) During the work process, when an abnormality is found in the machine, production should be stopped immediately and the machine should be shut down for maintenance in time. After inspection or repair, be sure to carefully check whether all parts of the machine are normal.

(2) The extruder must be lubricated and maintained regularly to ensure the normal operation of the extruder.

(3) The extruder should pay attention to the safe operating procedures during the production process. If any abnormality is found in the plastic sheet equipment, it should be shut down immediately for maintenance.